Milling steel on the shopbot
The OCD tingler! As we were doing some exeriments with cutting steel on the shopbot, we made this:
A binary dice made of steel, with some brass gears put inside before welded shut. The dice measures 50 x 50 x 50, and weighs in at 320 G. We cut the steel with casemaker pattern at 10mm/sek with a three flute 6mm bit, 1,5 mm at each pass.
The pieces where welded together at 50 amp with our TIG welder.
A binary dice made of steel, with some brass gears put inside before welded shut. The dice measures 50 x 50 x 50, and weighs in at 320 G. We cut the steel with casemaker pattern at 10mm/sek with a three flute 6mm bit, 1,5 mm at each pass.
The pieces where welded together at 50 amp with our TIG welder.
Kommentarer
Legg inn en kommentar